Troubleshooting
Symptom by symptom, what usually causes it and exactly where to look, so a test never stays blocked for long.
Most problems have a simple cause
A link that does not open, a page that stays blank, a heatmap without picture: in most cases, Launch Approved already says why, in the cockpit or in the campaign. This page gathers the usual symptoms and what to do.
- Look at the message first — the cockpit, the Behaviour tab and the Journey explain what they can.
- Check the campaign — its state, its dates and its settings decide a lot.
- Check the versions — the agency site and the client site should run the same recent one.
Still stuck? Write to us from the Contact page with the details listed at the end.
On this page
Links and access
| Symptom | What to do |
|---|---|
| « Link not valid » | The link was copied in part, or replaced by a new one: send a new link from the Testers tab. |
| Every link refused on one computer | Too many wrong links were tried from it: close the old cockpit tabs and wait an hour. The team, logged in, is never blocked. |
| « Not open yet » or « closed » | The campaign is a draft, paused or closed, or outside its dates: check the Overview tab. |
| « Taken on another computer » | Use « Reopen the test » in the Testers tab: a new link, the test goes on. |
| « Thank you » when opening a test | The test is done: use « Take the test again » if it must be redone. |
The product in the cockpit
- A blank or refused page — the site refuses to be shown inside another page: switch to analysis mode, or link it with the connector.
- « This page is outside the test » — the address is not allowed by the campaign: add it in the settings (addresses allowed).
- Plugins still active after switching them off — without the connector, only the analysis copy changes; with it, check that the client site runs a recent version.
Heatmaps and videos
- No clicks recorded — the site is outside, without the connector, or the client’s Launch Approved is too old: the Behaviour tab says so.
- No picture under the heatmap — the reason is shown under the map; capture the page by hand in the expert tools, Clicks tab.
- No video — the reason is shown for each test: a phone, the box not ticked, or the screen sharing refused.
- The browser asks to share the screen — it is its own rule for screenshots and videos: choose the tab of the test.
E-mails
- Not received — look in the spam folder, then install an SMTP plugin and set the sender in Settings.
- Reminders late or missing — they run with WordPress’s scheduled tasks: on a quiet site, set a real server cron.
- Sending failed — the Journey shows it in red: the server refused the e-mail.
Reports
- « Not ready to be signed » for the client — sign the report for the agency first.
- The report cannot be changed — it is signed for the agency: remove the signature, as long as the client has not signed. Once signed by the client, start the next round.
- Changes not visible in the preview — save the report first: the preview shows what the client sees.
- No Word or Excel button — the PHP « zip » extension is missing: ask your host to switch it on. PDF and CSV still work.
Before you write to us
Send the address of the page, your versions of Launch Approved and WordPress, the campaign concerned, the browser used and a screenshot of the message. From the Contact page, or see the FAQ first.